AutoSonar Reverse Backup Sensors Installation 01

AutoSonar Auto Reverse Sensors System - Installation Video.
2008 Honda Accord.
http://www.autosonar.com

---

Closed Caption:

George demonstrate how to install a
backup system are sewn on parking
assistance with the basic tools here
25
phillips screwdriver flat head
screwdriver or drill tape measure
marking the shopping whatever you like
test light flyers electrical tape
masking tape and this will be to run the
water through the from the front of the
back inside the kids have the sensors
included in the kit
it's also the drill bit that is used to
obviously thrilled with the border with
the sensors and which is the exact
measurement
we've had the unit
we have the display this would be to
extend the sensors to the the unit which
is actually pretty nice you plus if you
have one of the sensors to go bad
it's easily changeable
the floor to the hybrid you need to be
anywhere between 20 to 27 inches from
the floor
the reason for that is too low to pick
up the ground there for maybe a false
reading and this is what we have
it's perfect because we have a space
check back there's nothing in the way
it's perfect
my number is between the measurements of
this case is going to be about 22 and
you use your tape put it roughly 27
space in between
the next step is to find the center of a
person
where the trunk latches that's gonna be
the center so you just follow this year
down
use the screwdriver really just I
that will be your Center basically what
you're going to do from here
imagine from there to the center or were
you
you think it's another fit properly
even market with your tape
yeah
yeah
yeah
ok
so close to our sensors from there
divide the space in between there and
the center
yeah
yeah
ok next step is to figure out where the
other two centers in the center gonna go
if we remember when 27 inches
- 27
sign it
which is fitted for
provide that three that's good
the sensors 18
maybe with some always measure from our
sense in a way never from the center and
forget anything
I forget about the center that was only
to get the one of the central
all four sensors in the rough location
we're gonna go that that's going to be
even all too well the next step is to
figure out the high
remember earlier I mentioned from the
floor up
that was only two to get a rough
estimate that you're not to LA never
used the floor because the floor and
even happened so fast
it's actually
fix on the table
whatever makes you comfortable it could
be the curb
here it could be from here whatever
makes you comfortable as long as we do
it all through the bunker here within a
go
if you measure well go an inch down from
my curve of the bumper
ok now we have all the four sixes mark
and like said before you drill always
get behind the bar when you put you in
there make sure your mother is not hot
you're putting in there in the work
make sure there's nothing behind
drill always imagined lines whatever
makes you comfortable
from the San 727
yeah
again
let you add up both sides that you
divided into three
that's how you can use center to get
this mark here because you only putting
four sensors so forget about that once
you figured out the space and the back
there
don't burn yourself I usually like to
step back
make sure that everything looks right
even to the vehicle
ok take the tape off
yeah
every four balls drill down what you can
do with the you can use a screwdriver or
fly you pleased with what we want to do
is be sure and