How to tie picture frame wire Brisbane Picture Framer expla

http://www.fixaframe.com.au
How to fix picture framing wire to a picture frame Brisbane Picture Framing Workshop Fix-a-Frame Demo. Learn Picture Framing methods to enhance your home and lifestyle. http://www.youtube.com/watch?v=DjZxYR...

---

Closed Caption:

I've gone all the way around I've sealed
and typed that entire age in some cases
we put brown paper over that so that no
dust can getting that this seals it and
holds it together which is the important
part
I then turn it over just again to check
which way up at ease
that's going to hang this way on the
wall
so on the opposite corners there I place
two small felt pom pons
now these are there to help it stay
straight on the wall but also more
importantly promote air circulation
if you have a picture touching the wall
the picture itself will suck moisture
off the wall and go mouldy quicker so
this allows air to circulate behind it
and it gives no little ledge for insects
to to living and that also reminds me
which way the bottom is then what I do
is I measure down from the top and in
this case this frame is nearly 30
centimeters what long 300 millimeters
long
so I place the d-rings that are going to
hang the picture at one-third of that
distance
so in this case it's easy for me to say
i'm going to put it there at ten
centimeters or a hundred millimeters do
the same on the other side
i'm using it on all to make a small hole
you can drill it if you like with her
with a small battery drill but I just
make a little starter hole like that
then what I'm going to use to hang it
with d-rings d-rings of what picture
frame is used on the side of the frame
here and we put one on each side with a
small screw and that's going to be
drilled as
to the frame and so here with my battery
power drill ice cream bedding repeat
that on the other side
they do have us different side to them
there's a little loop side and a flat
side
it's very good to put the flat side down
I'm sure it doesn't make any difference
of the strength but the aesthetics are
better if you put it flat side down
you can't do that now we're going to use
some picture frame wire here
this is a plastic coated stainless steel
wire and we use it to hang most of our
pictures
now the trick with tying this wire is we
do have a little knot and what that is
we come up through the deering folded
around go around itself and back down
through the d-ring again
that makes a little sweet not just to
start with which keeps it tight on that
ring and doesn't slide you can then
twist the wire off if you just put it
through and twist it off
it will come up slip undone a few little
twist like that some people like to put
lots of twists on there we just put a
few like that and then using your wire
cutter just cut the excess piece of wire
off there
so we've got a nice little type piece
there are then pull more wire off and I
allow are about four inches or a hundred
millimeters of wire more than the length
of the frame there just so that it's
easy to work with and I cut that off
now we repeat the not on this side
now normally we don't pull that why did
tight because we want some slack in that
wire because when we hang it up on the
wall
we'd like to use maybe to picture books
so that we can get it to hang level here
and here and also it puts less strain on
the wire
so you repeat the knot out of the hole
around itself back in through the d-ring
again
give it a little pull tighten by pulling
the piece that actually hangs and then
twisted off neatly pulling each loop
hard up against the d-ring she go
so usually three or four twists like
that is plenty and then cut that off
so now we've got relatively loose wire
on the back of the frame
we've got some ponds in the corners we
can give it a pull to see if it hangs
and there we have our finished frame
ready to go on the war